Mylex AcceleRAIDTM 352 PCI to Ultra 160 SCSI RAID Controller AcceleRAID 352 Guía de instalación descargar pdf (Pagina 32)

SISL Installation Checklist

2-18 AcceleRAID 150 Installation Guide

SISL Installation Checklist

GET READY

☛ Note

It is recommended that you wear a grounded wrist

strap when working with hardware installation

procedures.

1. ____ Locate the prewired SISL slot, see your system documentation.

2. ____ Remove the plate from the I/O access port to the SISL PCI slot.

3. ____ Remove the AcceleRAID 150 controller from the anti-static bag.

4. ____ Check Jumper 10 (JP10). If it is not on the jumper pins, install it

to the ON position as shown in Figure 2-19.

GET SET

5. ____ Plug the AcceleRAID 150 controller into the prewired SISL slot.

6. ____ Tighten the AcceleRAID 150 controller into the mounting

bracket.

7. ____ Connect the SCSI cable(s) drives and/or devices to the controller.

8. ____ Check termination for both internal and external configuration.

9. ____ Check termination for embedded system channels.

10. ____ Remove or set termination jumpers to the disabled position on

the disk drive.

11. ____ Set SCSI ID on the disk drive.

12. ____ Enable termination power on the disk drive.

13. ____ Safety check the installation.

☛ Note

Review Figure 2-14 and Table 2-2 to get familiar with

the layout of the AcceleRAID 150 controller and the

Connectors, Jumpers, and LED descriptions.

14. ____ Go to Chapter 3, Controller Start-up.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 101 102

Sin comentarios

Mylex AcceleRAIDTM 352 PCI to Ultra 160 SCSI RAID Controller AcceleRAID 352 Guía de instalación Pagina 32