Mylex AcceleRAIDTM 352 PCI to Ultra 160 SCSI RAID Controller AcceleRAID 352 Guía de instalación descargar pdf (Pagina 17)

Installation

Manual No. 775020 2-3

1. Power OFF the system and any enclosures, such as a tower, and

disconnect the power cord and cables before starting the installation.

Refer to the instructions provided in your system documentation. Do

not disconnect cables or power cords while system power is ON.

2. Read all of the instructions in this chapter completely before proceed-

ing. Follow the Notes, Cautions, and Warnings described in this manual

and marked on the equipment.

3. Safety check the installation before powering ON the system:

• Make sure SCSI cables are properly connected.

• Make sure all SCSI conventions (cable type, cable length,

termination, and SCSI addresses) are followed. Examples of cable

types are: flat, rounded, shielded, or non-shielded – use like types

together.

• For information about cable lengths and formats, please refer to

Table A-1 on page A-1.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 101 102

Sin comentarios

Mylex AcceleRAIDTM 352 PCI to Ultra 160 SCSI RAID Controller AcceleRAID 352 Guía de instalación Pagina 17