Mylex AcceleRAIDTM 352 PCI to Ultra 160 SCSI RAID Controller AcceleRAID 352 Guía de instalación descargar pdf (Pagina 27)

Installation

Manual No. 775020 2-13

10. Remove or set disk drive termination jumpers to the disabled position

(if needed). Refer to your system documentation furnished with your

disk drives to determine if your termination jumpers need to be

adjusted.

11. Set the SCSI ID on the disk drives; ID 7 is reserved for the controller.

☛ Note

Each drive must have a unique ID chosen from

0 through 6 or 8 through 15. Be careful not to

duplicate a drive address on the same channel.

Remember: ID 7 is reserved for the controller;

therefore, it cannot be used as a disk drive ID.

ID’s from 0 through 6 are usually for Narrow,

8-bit devices. However, the full range of SCSI ID

addresses, 0 through 6 and 8 through 15 can be

used for Wide, 16-bit devices.

See your device documentation for instructions on

how to set your particular disk drive’s SCSI address.

Figure 2-12. SCSI ID Numbers

SCSI ID Numbers

7 is reserved for the controller

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 101 102

Sin comentarios

Mylex AcceleRAIDTM 352 PCI to Ultra 160 SCSI RAID Controller AcceleRAID 352 Guía de instalación Pagina 27