Mylex eXtremeRAID Guía de instalación descargar pdf (Pagina 104)

Running RAID Assist

4-54 GAM Client v3.00 and WSAM User’s Manual

4. Check the Init Drive box if you want this logical drive to be fully

initialized at the conclusion of the configuration. It is recommended

that you check this option (if available), unless the controller is capable

of background initialization. If so and you check the box, you’ll see a

message when you apply the configuration indicating that you can

make use of the background initialization support.

5. Select a stripe size.

6. Select a cache line size, if enabled. Available settings will depend on

the selected stripe size. (Not available for External RAID Controllers.)

7. Click the Add Drive button to register your new logical drive.

8. If you are configuring a Mylex PCI RAID Controller, click Apply to

save the configuration if you are finished setting up logical drives, OR

Repeat the process above to set up additional logical drives, then click

Apply when you’re done.

If you are configuring a Mylex External RAID Controller, click the

Lun Mapping tab to continue with configuration (see “LUN Mapping

in Global Array Manager (FW 5.x or below)” on page 4-57 or “Host to

LUN Mapping in Global Array Manager (FW 6.x or above)” on page

4-61), OR

Repeat the process above to set up additional logical drives, then click

the Lun Mapping tab when you’re done.

An example of a completed Manual configuration is shown in Figure 4-48:

1 2 ... 99 100 101 102 103 104 105 106 107 108 109 ... 209 210

Sin comentarios

Mylex eXtremeRAID Guía de instalación Pagina 104